User Manual

7.7. Waveform Saving Setups
The oscilloscope can save 4 waveforms, which can be displayed on the screen with the present waveform.
The recalled waveform saved in the memory cannot be adjusted.
The waveform saving /recalling menu is described in the following list.
Function menu
Setups
Description
Source
CH1
CH2
MATH
Make sure the waveform you want to save appears in the display.
Select the displayed waveform which you want to save.
WAVE
A, B, C and D
Select the address for saving or recalling a waveform.
Save
Store the waveform of a selected signal source into the selected
address.
Show
ON
OFF
Close or start displaying the waveforms stored in address A, B, C or
D.
To save a waveform on CH1 in address A, do the following:
1. Press the MENU key and the function menu appears at the right of the screen.
2. Press the MENU ▲ or MENU ▼ key to select the Waveform Saving. Four options are displayed at the
bottom of the screen.
3. Press the F1 key to select the signal source CH1.
4. Press the F2 key to select the address A.
5. Press the F3 key to save the waveform on CH1 in address A.
To display the saved waveform on the screen, do the following:
6. Press the F4 key to select Start for the address A. The waveform saved in address A will be displayed
on the screen in green color.
The display color is green, and the zero point of waveform, voltage and time is purple.
Now, you can see a screen that looks like the following Figure.
Figure 47: Waveform Saving
-100-