User Manual

Operations for various control keys are shown as below:
* The CH1 VOL and CH1 ZERO for CH1 are used to set the horizontal scale and position.
* The CH2 VOL and CH2 ZERO for CH2 are used to set the vertical scale and position continuously.
The following functions do not work in the XY display mode:
* Reference or digital value waveform
* Cursor
* Auto Setting
* Time base control
* Trigger control
7.6.4. Cymometer (only PeakTech
®
1195)
It is a 6 digits cymometer. Its measurement range of frequency is 2Hz to full bandwidth. Set up cymometer
limit to “ON” status, when the triggering mode is edge triggering. It is a one channel cymometer and it can only
measure the frequency of the tiggering channel.
When the triggering mode is alternating triggering, it is a two channel cymometer and it can measure the
frequency of two channels.
To make a cymometer setting, do the followig:
If you want to measure frequency of the two Channels, you can do as the follows:
1. Press MENU, the function menu will appear on the right of the screen.
2. Press MENU ▲ or MENU ▼ and choose Display Setting, five options will show at the bottom of the
screen.
3. Press F5 and choose ON.
Figure 46
-99-