User Manual

3. Press the F1 key to select the frequency measurement as CH1. The measurement window on the
screen turns into one red in color and shows the frequency of CH1.
4. Press the MENU ▲ or MENU ▼ key to select Measurement 2. Five options appear at the bottom of the
screen.
5. Press the F4 key to jump to the peak-to-peak measurement as CH2. The measurement window on the
screen turns into one blue in color and shows the peak-to-peak value of CH2.
Now, you can see a screen that looks like the following Figure:
48: Automatic Measurements
7.10. Setting the Cursor Measurements
This oscilloscope allows you to make manual cursor measurements on time and voltage. The signal sources
include Channel 1(CH1), Channel 2 (CH2).
The cursor measurement menus are listed and described in the following table.
Function menu
Settings
Description
Type
OFF
Voltage
Time
Close the cursor measurement.
Display the voltage measurement cursor and
menu.
Display the time measurement cursor and menu.
Source
CH1, CH2
Select the waveform channel on which the cursor
measurement will be performed.
Delta
Display the difference of measured value between
the two channels.
Cur1
Display the relating measured value of Cursor 1
Cur2
Display the relating measured value of Cursor 2
To make a voltage measurement on CH1, doing the following:
1. Press the MENU key and the function menus are displayed at the right of the screen.
2. Press the MENU ▲ or MENU ▼ key to select Cursor Measurement. Two options are shown at the
bottom of the screen.
3. Press F1 key to select the measurement type Voltage. Two purple crossing dashed lines V1 and V2 are
shown on the screen.
-103-