User Manual

7.8. Function Setting Menu
The function setting menu is described in the following list.
Function menu
Setting
Description
Recall Factory
Resume the instrument to its factory settings.
Auto Calibration
Perform the Auto-calibration procedure.
Language
Chinese
English
Polish
Russian
German
Spanish
Select the display language.
Auto-calibration
The Auto-calibration function automatically configures internal parameters to maintain the sensitivity and
accuracy. Run the Auto-calibration in the following cases:
When the temperature fluctuates more than 5 degrees Celsius during operations.
When operating the oscilloscope in a new bench top or field environment.
1. Press the MENU key and select the FUNCTION menu using the Up/Down key.
2. Press F2 (Auto calibration). A message appears on the display, asking you to remove all cables and
probes from oscilloscope.
3. After removing all cables, press F2 (Auto calibration) again. The Auto-calibration automatically starts and
a message appears, showing that the calibration is ongoing.
To interrupt calibration, press any key during the calibration.
7.9. Making Automatic Measurements
The oscilloscope can perform 20 types automatic measurements such as frequency, cycle, average
value, peak-to-peak value, root mean square value, Vmax, Vmin, Vtop, Vbase, Vamp, Overshoot,
Preshoot, RiseTime, Fall Time, +Width, -Width, +Duty, -Duty, DelayA B and DelayA B . And gives
two kinds of measurement results simultaneously on the screen.
The function menu for automatic measurements is described in the following tabel.
-101-