User Manual

- 74 -
Duty cycle setting
Select Duty Cycle in the right menu of the pulse waveform, then set the parameters in the right menu. (If
Duty Cycle is not displayed, select Width and then press this button again to switch back to Duty Cycle).
Arbitrary signals
The parameters of the arbitrary signal in the right menu are: Frequency/Period, Amplitude/High Level,
Offset/Low Level, Built-in Waveform, Editable Waveform.
Note: Do the possible settings for frequency, amplitude etc. as described on the previous page for the sine
signal.
There are two types of arbitrary waveforms: Built-in waveforms and user-generated waveforms.
Integrated waveforms:
1. Press the AFG button on the unit to display the generator menu.
2. Select Arb in the bottom menu, then Built-in in the right menu.
3. Select Common, Math, Windows or Others from the right-hand menu. Use Others, for example, to
open the following interface:
4. Turn the M-rotary knob to select the desired waveform (or via touchscreen) and confirm the selection with
the Select function in the right menu.
Note: To output a DC voltage, press the DC button on the unit.