User Manual

- 102 -
11. Appendix
Appendix A: Scope of delivery
Standard accessories (depending on model):
1 x Carry bag
2 x probes 1.2 m, 1:1 (10:1) for 2-channel models / 4 x probes 1.2 m, 1:1 (10:1) for 4-channel models
2 x BNC cable (4 x for 4 channel models)
1 x CD (software, BDA and driver)
1 x power cable
1 x USB cable
2 x test leads multimeter (multimeter models only)
1 x multifunctional base
Appendix B: Maintenance and care
General maintenance:
Please do not store or operate the unit in locations where the LCD screen is exposed to direct sunlight for
extended periods of time.
Caution:
Avoid damaging the unit or probe with sprays, liquids or thinners.
Cleaning:
Check the condition of the probe and the unit at regular intervals. Clean the outer surfaces of the unit as
follows:
Remove dust from the unit and the probe with a soft cloth. Avoid scratching the transparent protective
screen of the LCD screen when cleaning it.
Clean the appliance with a soft, damp cloth that has been wrung out well, unplugging the power cord
from the wall socket first. Use a mild detergent or clear water. Avoid using aggressive cleaners, which
can damage the unit and the probe.
Warning: Make sure the appliance is completely dry before putting it back into operation. Otherwise
there is a risk of short circuits or electric shocks.
NOTE:
Please install the supplied software including all USB drivers before connecting the PeakTech® Oscilloscope
to your PC.
Appendix C: Cloning a Waveform
Press Save. Select Type in the lower menu, in the left menu, turn the M knob to select Clone.
You can clone one or two channel waveforms between two cursors and save them as a cloned waveform in
the internal memory or on a USB storage device. You can store four cloned waveforms in the instrument's
internal memory. The cloned waveform files stored on a USB memory device are saved with the extension
"ota".
If the optional Arbitrary Function Generator is available in your instrument, you can output the stored
waveform from a file in internal memory or a USB memory device. and the waveform between two cursors
can be output directly without any memory operation.
You can also use the PeakTech 4125 or 4165 signal generator to read * .ota files and retrieve the cloned
waveforms.
Clone Wave menu shows the following: