Owner's Manual

11 12
General Usability FCC warning
1. The universal wheels are for indoor flat ground and short distance only. Please don't
move it to outdoor or long distances, otherwise it might cause unnecessary damage to the
wheels. In case of any wheels problems, please ask technical teams for simple fixing
instructions.
2. Please don't pull out the cables without the machine powered on. Otherwise it might cause
the cables to not retract.
3. Please don't pull the cables at a fast speed(0.5s/meter) when it's in small res
istance
below 22lb.
4. Please don't bend the cables or press another force onto them. Otherwise it might cause
permanent deformation, resulting in cables not retracting.
5. As this is a new product, misusing it might cause some minor errors. In case of any error or
issues, please ask our technical teams for simple fixing instructions.
Product Specification
Product Size( L× W× H)
120.5×58.5×19.4cm
Folding Size( L× W× H)
58.5×38.8×62.6cm
Packaging Size( L
× W× H)
134.5×68.5×22cm
Maximum Load
330 lb
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
The antenna(s) used for this transmitter must be installed to provide a separation distance of at
least 20 cm from all persons and must not be collocated or operating in conjunction with any
other antenna or transmitter, End-Users must be provided with transmitter operation conditions
for satisfying RF exposure compliance.
Platform