User`s manual

24
Range
Once the trigger port is detected, the incoming packets are allowed to
pass the firewall to these already specified Incoming Ports.
Trigger Type
Click the down arrow b to select the trigger type (TCP or UDP)
Trigger Start
Port
Enter a port number as the starting outbound port for the special
application defined in the preceding field.
Trigger Finish
Port
Enter a port number as the ending outbound port for the special
application defined in the preceding field.
Save
Press to save the new settings on the screen.
Undo
Press to discard the data you have entered since last time you press
Save.
WAN Port
WAN Access Type
Select the WAN access type (Static IP, DHCP, PPPoE
and PPTP) from the pull-down menu.
DNS 1-3
Enter the DNS server IP address(es) provided by your
ISP, or you can specify your own preferred DNS server
IP address(es).
DNS 1 and DNS 2 servers are optional. You can enter
another DNS server’s IP address as a backup. DNS 1 and
DNS 2 servers will be used when the DNS 1 server fails.
Clone MAC Address
Your ISP may require a particular MAC address in order
for you to connect to the Internet. This MAC address is
the PC’s MAC address that your ISP had originally
connected your Internet connection to. Type in this Clone
MAC address in this section to replace the WAN MAC
address with the MAC address of that PC.
 Enable uPNP
 Enable Ipsec pass through
on VPN connection
Check to enable the listed functions.