User`s manual

23
numbers or by names.
Maximum 24 Server entries are allowed and each port
number can only be assigned to one IP address.
Local IP Address
Enter the Local Server’s IP address.
Protocol
Select the protocol (TCP, UDP or Both) used to the remote system
or service.
Port Range
For TCP and UDP Services, enter the beginning of the range of
port numbers used by the service. If the service uses a single port
number, enter it in both the start and finish fields.
Description
You may key in a description for the local IP address.
Save
After completing the settings on this page, click Save to save the
settings.
Reset
Click Reset to restore to default values.
Special Application
If you use Internet applications that use non-standard connections or port numbers, you may
find that they do not function correctly because they are blocked by the Wireless Router's
firewall. In this case, you can define those applications as "Special Application" so that they
can function properly.
You can define your Special Applications. You will need detailed information about the
application such as number of port required; this is normally available from the supplier of the
application.
Also, note that "Incoming" on this screen refer to traffic from the client (PC) viewpoint.
You have to firstly check Enable before you can add/edit an application.
Name
Enter the application name.
Incoming Type
Click the down arrow b to select the incoming application type (TCP
or UDP)
Incomin
g
Port
Enter one or more set(s) of port number range as the incoming ports.
hi id dhi i k
l
ld