User Guide

10
EN YOUVI Netatmo Bridge, Getting started
1 Which devices are connected?
With this bridge, various Netatmo devices are integrated into the YOUVI visualisation. The
values measured by the Netatmo devices – but also defined setpoints of the thermostats – are
displayed and operated in YOUVI in the usual widgets:
Netatmo device Device type in YOUVI
Smart Thermostat, Smart Radiator Valve Heating
Smart Weather station, outdoor module Sensor: Humidity, temperature, pressure
Smart Weather station, indoor module Sensor: Humidity, temperature, noise, CO
Smart Anemometer Sensor: Wind direction, wind speed
Smart Rain Gauge Sensor: Rain gauge
Anemometer/outdoor module
Weather station (contains values for wind
direction and speed, temperature and
humidity)
 Note: Once created in YOUVI, Netatmo devices are not only available in the visualisation,
but also in the Logic module and in the YOUVI Mobile App.
2 Setting up Netatmo units
▪ Use the supplied documentation to set up the desired Netatmo appliances.
3 Installation
▪ Open the Dashboard page of the desired YOUVI server. For more Information refer to
Appendix – Further Information
▪ Select the house of the desired add-on to install it. Confirm the message.
▪ Under More > Licence you can view the remaining days of your trial licence.
▪ For unlimited use, please purchase the add-on in the PEAKnx Shop.
▪ Return to the Dashboard page. Select the house of the add-on to open it:.