User's Manual

Communication
Systems Inc.
PDI-P19LCDC Quick Start Guide
Page 11 of 12
Better Solutions Are Within Reach™ INSTALLATION INSTRUCTIONS
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH [phone] FX [phone]
Document Number: PD196I126R1.DOC
DVD Module Operation
WARNING: AC power supply must be disconnected
before installing the DVD Player. Failure to do so will
cause irreversible damage to the TV.
DVD Module Installation
Refer to the illustration below and follow the procedures below to install the DVD Module onto the LCD TV.
1. Plug one end of the cable into the DVD module and the other end to the LCD TV.
2. Carefully slide the module into the desired position and lock the module with the screw.
Enable DVD Module
Now that you have the DVD Module installed, it needs to be enabled by using the programming menus. After the DVD Module is
enabled, it is ready for use.
1. Plug the Power Cable into the wall outlet.
2. Turn on the TV.
3. Press SETUP on the programming remote, PD108-420.
4. From the SETUP menu, press ▲ or ▼ to highlight Sources.
5. Press ► to select it.
6. Press ▼ to highlight SLOT DVD.
7. Press ◄ or ► to change the source status to Enable/APO.
8. To exit, press SETUP until the programming menus disappear.