User's Manual

Document Number: PD196-120 Rev 2

Enabling / Disabling Sources

The TV’s signal sources can be individually Enabled or Disabled. A TV that is switched to a

non-connected source generates nuisance hospital maintenance calls of “TV Not Working”, when

in fact the TV does work, but has been set to an inactive source. Please Disable all of the TV’s

sources that are not to be used.

1. From the SETUP menu, press the CH+/- or ▲/▼ direction buttons select Sources. Then press

the VOL+/- or ◄/► direction buttons to enter.

2. Press the CH+/- or ▲/▼ direction buttons to select a source.

3. Press the VOL+/- or ◄/► direction buttons to change the source status to either Disabled or

Enabled as desired. NOTE: Sources that are grayed out are not installed in the TV.

4. Press the SETUP button to exit.

Power On Source

The TV can be preset to power on to a selected source.

1. From the SETUP menu, press the CH+/- or ▲/▼

direction buttons select Sources. Then press the

VOL+/- or ◄/► direction buttons to enter.

2. Press the CH+/- or ▲/▼ direction buttons to select

Power On Source.

3. Press the VOL+/- or ◄/► direction buttons to change

the source.

NOTE: The source must be enabled before it can be

chosen as a power on source. The “LAST” entry causes the TV to power on from the “LAST”

source selected.

4. Press the SETUP button to exit.

Source Setup