User's Manual

Document Number: PD196-120 Rev 2
39
Signal
Four different tuning types are available depending upon the healthcare facility’s signal style.
Selection of the correct signal type is required for the TV to recognize all possible channels and
before any channel programming can begin.
1. Press the OK button to display the SETUP menu.
2. Press the CH+/- or ▲/▼ direction buttons to select Channels item and press the VOL+/- or
◄/► direction buttons to enter the Channels menu.
3. Press the CH+/- or ▲/▼ direction button to select Signal.
4. Press VOL+/- or ◄/► direction to select Air, Cable STD, Cable IRC or Cable HRC. NOTE:
Most hospitals use the Cable STD signal style.
Auto Program
The TV automatically scans each available channel for activity. Channels that display activity are
memorized into the selected Service Level.
1. Press the OK button to display the SETUP menu.
2. Press the CH+/- or ▲/▼ direction buttons to select Channels item and press the VOL+/- or
◄/► direction buttons to enter the Channels menu.
3. Press the CH+/- or ▲/▼ direction buttons to select Auto Program item and press the ►
direction button to enter the Auto Program menu.
4. Press the CH+/- or ▲/▼ direction buttons to select Mode.
5. Press the VOL+/- or ◄/► direction buttons to set the scope of channel scanning.
Analog Only: TV searches for analog channels only.
Digital Only: TV searches for digital channels only.
Analog and Digital: TV searches for both analog and digital channels.
6. Press the CH+/- or ▲/▼ direction buttons to select Channel Sequence menu item.
Channel Setup