User's Manual

Document Number: PD196-120 Rev 2
34
Service Level
The TV can be configured with 3 different banks of channels called Service Levels. Each Service
Level can be programmed with any combination of channels. For example, a hospital usually elects
to dedicate one of the service levels for Pediatrics and another for Maternity since additional or
banned channels may be found in either location that would not be normally shown to the general
patient population. A DISABLED service level is also available that does not display any channels
but rather a disabled message on the TV’s screen when the TV is turned on.
To change a Service Level.
1. Press the OK button to display the SETUP menu.
2. Press the CH+/- or ▲/▼ direction button to highlight
Service Level menu item.
3. Press the VOL+/- or ◄/► direction buttons to select
the desired service level.
4. Press the SETUP button to exit.
Picture
Adjustment of picture Brightness, Contrast, Color, Tint, Color Temperature, Sharpness is available
to customize the levels you prefer using the on-screen menus.
1. Press the OK button to display the SETUP menu.
2. Select the Picture menu item.
3. Press the CH+/- or ▲/▼ direction
button to highlight the desired picture item.
4.
Adjust the picture item using the VOL+/- or ◄/► direction buttons to the desired level.
5.
Press the SETUP button to store the picture values.
NOTE: A separate set of picture parameters are available for computer (PC Analog/HDMI Picture)
or external devices such as DVD’s (Component Input Picture).
Service Level
NOTE: If a service level is selected that is empty, and has not been programmed
with channels, a warning message will be displayed on the TV stating “No Channels
Available, Please Contact a TV Representative.” To eliminate this message switch
the TV to a Service Level that has been programmed with channels.