User's Manual

Page 8 of 11
Pillow speaker
A ¼” stereo-style pillow speaker (pendant control) jack is located on the TV’s connector panel on the backside. This TV is designed to
work with either a digital pillow speaker that generates digital-style control codes or a single-button analog (switch-style) pillow
speaker. A rear panel mounted switch allows use of different brands of pillow speakers and supports the major brands: Zenith, Philips,
and RCA.
CAUTION: Confirm the pillow speaker type and set the side switch appropriately
BEFORE connecting the pillow speaker to the TV. Failure to follow this procedure could
result in damage to the pillow speaker and/or TV.
Pillow Speaker and Antenna Connection
CAUTION: Some hospital
cable systems provide
power voltage on the coaxial
cable. This TV is NOT
designed to be powered via
a coaxial cable. DO NOT
connect to a powered
coaxial cable. Damage will
result to the TV.
Across-Room Wiring
NOTE: A Jumper Cable is NOT supplied with the TV and must be ordered separately.
Programming
A programming remote control (PD108-420) is used to perform all setup operations for the TV.
SPEAKER
DATA / SWITCH
COMMON
SPEAKER
DATA / SWITCH
COMMON
¼” to ¼” Jumper Cable
¼” to 6-Pin Jumper Cable
PD106-417
PD106-416
ACROSS ROOM WIRING
WARNING: DO NOT connect
the pillow speaker circuit
Common to earth ground.
Grounding of the Common will
defeat the isolation circuitry of
the TV and possibly expose the
patient to harmful shock
currents should a wiring fault
occur.