User's Manual

Page 7 of 11
Wall Mounting for CLEAR VIEW-CV32LCD TV
The CLEAR VIEW-CV32LCD require a PD181-672 200mm to 100mm Adapter Plate (Not supplied with TV), a PD181-596 LCD
Mounting Bracket (Not supplied with TV), and a PD181-674 HD Extended LCD Tilt Clevis (Not supplied with TV) to be mounted to
the wall.
1. Refer to Figure 1. For the CLEAR VIEW-CV32LCD find a
location on the wall 10.5 inches below the ceiling to mount
the HD Extended LCD Tilt Clevis (wall mount).
NOTE: DO NOT locate AC, Across-Room
Wiring, and CATV Signal outlets below the
Wall Bracket’s location as it will cause
clearance issues and interfere with the TV’s
cabinet when mounted to the bracket.
2. Position the HD Extended LCD Tilt Clevis and locate two
mounting holes. Place one of the supplied ¼” flat washers
(CLEAR VIEWFW25) and the ¼” lock washer (CLEAR
VIEWSLW25) on a ¼” screw (not included) and insert it into
the top mounting hole of the clevis. Secure the clevis to the
wall. Place the other supplied ¼” flat washer on another ¼”
screw and insert it in the bottom mounting hole. Secure it to
the wall and tighten both screws.
3. Refer to Figure 2. Attach the LCD mount to adapter plate
using the four M4 screws (CLEAR VIEWPPHMSM4X76)
and four #10 Internal Tooth Lock washers (CLEAR
VIEWITLW10).
NOTE: The side with the four hex sides will
go toward the back of the set.
4. Position the mounting bracket and adapter plate on the LCD
TV cabinet. Attach with the four M6 screws (CLEAR
VIEWPPHMSM6X110) that are provided.
Mounting Connections
Mounting Pieces
Part # Part
PD181-672
200mm to
100mm
Adapter Plate
(1)
PD181-596
Figure 2
LCD Mounting
Bracket (1)
HD Extended
LCD Tilt Clevis
(1)
PD181-674
Screws and Washers
PD181-596: LCD
Mounting Bracket
CLEAR
VIEWPPHMS1
03238
10-32X3/8
PPHMS (2)
#10 Internal
Tooth Lock
Washer (6)
CLEAR
VIEWITLW10
CLEAR
VIEWPPHMSM
4X76
M4-.7X6mm
PPHMS (4)
CLEAR
VIEWPPHMSM
6X110
M6-1X10mm
PPHMS (4)
CLEAR
VIEWFW25
¼” flat washer
(2)
CLEAR
VIEWSLW25
¼” lock
washer (1)
Numbers in parenthesis represent
quantity
PD181-672: 200mm to
100mm Adapter Plate
PD181-674: HD Extended
LCD Tilt Clevis
5. Mate the mounting bracket to the clevis making sure
the resting pins are inserted in the two notches at the
front of the clevis. Secure with the two 10x32 screws
(PDIPPHMS103238) and the two remaining Internal
Tooth Lock washers.
6. The TV’s tilt can be adjusted by loosening both Pilfer
Screws, adjusting tilt, and then tightening the screws.