User's Manual

9
Document Number: PD196-167R2
Pillow Speaker Sound Setup
Proper setup of the TV’s Sound is required for use with a
wired Pillow Speaker. Setup involves disabling the TV’s
internal speakers and then setting the audio level to the
pillow speaker.
1. Press the setup button on the handheld programming
remote control.
2. From the Setup menu, select Sound.
3. In the Sound menu, select Internal Speaker
Enable.
4. In the Internal Speaker Enable menu select the
source you wish to disable. For television select TV.
5. For Pillow Speakers with a thumb wheel volume con-
trol, in the Sound Menu, select Minimum Volume,
and set the level to approximately 50% to provide a
xed level of sound for the pillow speaker to adjust.
NOTE: Pillow Speakers with dedicated Volume Up
and Volume Down buttons do not require a Minimum
Volume adjustment.
Internal Speaker Enable
S
p
eake
r
■ TV Disabled
■ Composite Video Disabled
■ S-VIDEO Disabled
■ Component 1 Disabled
■ Component 2 Disabled
■ HDMI 1 Disabled
■ HDMI 2 Disabled
■ PC-ANALOG Disabled
■ FM RADIO Disabled
Position: ST
Exit: SETUP
Next: WX
SETUP
■ Service Level Free
■ Picture ▶
■ Sound ▶
■ Channels ▶
■ Features ▶
■ OSD Language English
■ Sources ▶
■ FM Radio ▶
Position: ST
Exit: SETUP
Next: WX
Sound
■ Balance 0
■ Minimum Volume 0
■ Maximum Volume 100
■ Power On Volume Last
■ Internal Speaker Enable ▶
■ HDMI 1 Audio Port HDMI 1
■ HDMI 2 Audio Port HDMI 2
■ Composite /S-Video Sound Mode L+R
Position: ST
Exit: SETUP
Next: WX
Sound
■ Balance 0
■ Minimum Volume 50
■ Maximum Volume 100
■ Power On Volume Last
■ Internal Speaker Enable ▶
■ HDMI 1 Audio Port HDMI 1
■ HDMI 2 Audio Port HDMI 2
■ Composite/S-Video Sound Mode L+R
Position: ST
Exit: SETUP
Next: WX