User's Manual

Rear Panel
1. HDMI Jack
Connection for HDMI device.
2. COAXIAL Jack
Provides a digital audio output signal for connection
to an external digital audio device.
3. COMPONENT IN
Connect the COMPONENT audio/video output
sockets of the DVD to the COMPONENT audio/video
input sockets of the set.
4. COMPOSITE/S-VIDEO IN
Connect the Video/S-VIDEO outputs of external
equipment to this input.
Connect the audio cable from the external equipment
or S-VIDEO VCR to the L & R IN of the set.
5. VGA IN
Connection to the video output jack on your PC.
6. ANT TV Jack
Connection to TV antenna.
7. CCI
Communication port.
8. MTI
Connect to MTI device.
Note: CCI and MTI can not be connected to the
external public network, and can be used by the
technician only.
9. VGA AUDIO IN
Connect the audio cable from the PC to the AUDIO
IN of the set.
10. SD Card Slot
Firmware upgrading purpose.
11. PILLOW
Pillow speaker port.
Use the switch to select correct voltage.
CZ: Zenith Compatible (+14V)
CP: Philips Compatible (+5V)
CR: RCA Compatible (-5V)
Off: Pillow port disable (0V)
NOTES:
Moving this switch changes the voltage supplied to
the pillow speaker.
Make sure it is set correctly BEFORE plugging in the
pillow speaker jumper cable.
Failure to do so WILL RESULT IN THE PILLOW
SPEAKER BEING OVERDRIVEN AND POSSIBLE
DAMAGE TO THE PILLOW SPEAKER.