User Manual

Fritz Building Instruction December 2020
www.pcm.at 8
With the help of the second green
part you can mark the area, which
you have to prepare for the gluing.
Grind this area well. Prepare also
the areas at the aileron.
Put enough CA to the gluing
areas and place the carbon part
accurately with tweezers.
Grind the next gluing areas well.
Don´t forget to grind also the
areas on the steel.
Save the kevlar hinge with a tape
from getting glued.
Then you can glue the steel with
the help of a snack bag into the
outer control.
After curing of the epoxy you
should check the accuracy of the
controls. When the aileron is in
zero position, the outer control
should also be in zero position. If
it isn´t, you can bend the steel a
little. To do this without breaking
anything, hold the controls
strongly, where the steel is inside,
and then bend till the deflections
are equal.