User Manual

Fritz Building Instruction December 2020
www.pcm.at 7
To achieve the best strength of
the wing the carbon cover should
be glued into the fitting.
The leading edge of the wing
sometimes dashes against the
ground. So it is heavily loaded. To
avoid damages, the carbon cover
has to be glued to the wing.
In the first picture you see the
grinding of the depression.
Outer controls
Here you see the parts you need
for moving the outer control with
the aileron.
First of all, glue the green part into
the prepared depression.
Remove any glue, which is on the green part. The green part gives the
emerging pocket its height. If anything is higher, the steel inside wouldn´t
fit well.
The steel, which joins the two
control surfaces, has to be bent at
the dimensions you see in the first
picture.
Before bending smoothen the end
of the 20mm part.
This is the part, which moves in
the pocket. To avoid scratching it
has to be smooth.
The 16mm end has to be bent
rectangular. The 20mm end a little
bit less.
To find the right angle just lay
your steel on the picture and
compare the angles.
The 20mm end has to be bent
also a little bit backwards, as you
see in the right picture. This back
bending doesn´t have to be so
exactly, because you can adjust it
also when it is already glued to
the wing.