User Manual

Fritz Building Instruction December 2020
www.pcm.at 6
Set the servo to zero position. The
real zero position of the X08
servos is 1520 not 1500.
Fix the aileron in zero position and
transfer the hole position of the
servo lever to the steel rod.
Bend the steel at this point in a right angle, cut it at about 4mm behind
and put it into the lever hole.
Then fix the wooden frame with just some spots of CA.
Remove the servo and glue every edge extensively.
Set back the servo into the frame. Make sure that you have screwed the
lever to the servo well. Screw also the servo to the frame.
To avoid the steel from falling out of the hole, glue the little plywood
block to the servo frame.
The servo cable can now be soldered to the cable, which leads to the
receiver.