User Manual

Fritz Building Instruction December 2020
www.pcm.at 5
Then you can put it into the hole of the lever and save it from falling out
with the shrinking tube. This shrinking tube you can also save with a
drop of CA.
Prepare the lever slot for gluing.
Grind it till the lacquer is removed.
Then you can glue the lever into
the slot with runny CA.
Fixing the servos
First of all prepare the surfaces, which will be glued. Grind them with a
rough paper (grain size 80).
It is easier to put the cable into the
wing before you start gluing the
servos.
Prepare the servo lever. Use the
inner hole and widen it. The
easiest and best fitting way is to
heat the steel and push it into the
hole. Let it cool down and remove
it. So the fitting is perfect without
using a drill.