User Manual

Fritz Building Instruction December 2020
www.pcm.at 10
Put in the plug into the milled slot
of the wing. Let it stand out of the
wing surface about 1mm, so that it
can be glued well with CA.
Here the switch is shown again.
6. RECEIVER ANTENNA
We recommend receivers with
two antennas. Drill two holes on
the lower and upper side to lead
the antennas out.
At last the space for receiver and
battery should be closed by gluing
the carbon cover to the
depression.
As told before, this is important to
provide a maximum of strength.
7. TUNING
Cover for throwing holes
Stretch the latex foil a little bit with
the help of four tapes.
Cover the frame at the glossy side
with thin double sided tape.