User Manual

Erwin XL slope building Instruction August 2018
www.pcm.at 6
ASSEMBLING THE MODEL
5. V-tail
The v-tail is ready prepared with holes for screws to be
fixed on the fuselage.
Controlling of the elevator:
Bend two brass levers as shown below and glue the ball
connectors to one end each. Then glue the levers to the
control surfaces of the elevator. The gluing spot should
be as near as possible to the turning axis of the controls
(silicone hinge).
Ready mounted levers with ball connectors.
(Here to be seen on Erwin XL ultralight)