User Manual

Erwin XL slope building Instruction August 2018
www.pcm.at 11
9. Installation of antenna
If you want to install 2,4 Ghz, let the antennas stand out
of the carbon fuselage as shown on the photo of Elvira.
The angle between the antennas should be 90°.
35 / 40 MHz:
As Erwin XL slope is completely made of carbon, a part
of the antenna must be situated outside the model.
One possiblity is to „extend“ the fuselage at the rear end
with a steel wire of about 450mm. Fix the end of the
antenna to this steel wire.
Another solution is to fix the antenna to the end of the
elevator. Lead the antenna inside the fuse behind the wing
and then leave the fuselage. You should add the length
between receiver and the breakthrough of the fuselage to
the end of the antenna, so that the original length of the
antenna is completely outside the fuselage.
Always test the reception on ground before you fly!