User Manual

Erwin XL slope building Instruction August 2018
www.pcm.at 10
For gluing the lever use epoxy-glue with cotton flocks.
When fitting the lever in the correct position, notice that the
hole in the lever should be situated vertically above the
hinge line.
To connect the servos to the levers use two connectors
M2,5mm. In between, use a welding rod (diameter 2mm),
which you solder inside the both connectors.
To find the right length of the welding rod put all servos in
0-position. If the length isn’t exact after soldering, you can
heat the soldered point with the soldering iron until the
the wire can be moved to the correct position.
The root ribs have recesses for the plugs between
fuselage and wings for easy electrical connection.
Fix the covers of the servos with a double-sided adhesive.
In order to move the triangular ends of the ailerons,
connect the two control surfaces with an adhesive tape.