Manual

English

6.3 Making a measurement

To make a measurement, the sensor must be attached to the desired measuring spot using a

stud bolt or the magnetic adaptor. When measuring with the optionally available measuring tip,

ensure correct alignment.

In measuring mode, the measurement is carried out continuously and the current value is

displayed on the screen.

If ISO evaluation is activated, the measured value is automatically assigned to the corresponding

zone on the basis of the selected grouping and highlighted in colour so that a quick assessment

of the vibration severity is possible. In addition, the corresponding zone flashes periodically.

6.4 Memory

By pressing the OK key while the measurement screen is opened, the current measured value

can be saved. This is confirmed by a corresponding message at the bottom of the screen. A folder

number and the measured value index are displayed. The measured value is displayed in the

currently selected folder which can be selected via the menu. A total of 99 folders with 50 readings

each is available.

If the maximum number of measurements is already saved in a folder, a message is displayed

when an attempt is made to save another measurement. In this case, a different folder can be

selected or saved measurements can be deleted.

The saved measurements can be viewed again via the menu item Memory > Display data.

The desired folder must be set beforehand via the corresponding menu. The measurements can

also be read out with the PC software.

Saved measurements can be deleted either individually, completely for the current folder or

completely for all folders via the corresponding menu items.

Fig. 30 Manual memory