Manual

© PCE Instruments
44
English
You can set a minimum value as the lower limit and maximum value as the upper limit.
If the measured value of at least one of these sensors is outside this set range, the data logger’s
LED will flash in red.
The red LED will go off as soon as all readings are back within the set range.
A measurement can be started in three different ways:
- Instant:
When the window for starting a measurement is closed by clicking on „Apply“, the measurement
is started.
- By keystroke:
The measurement is started when the Start or Stop key of the data logger is pressed.
- By time:
You can set a date and time or a duration for starting a measurement.
Note 1:
By clicking on the „By time“ button, you can take over the current time of your PC as the time
shown in that window.
Note 2:
The data logger synchronizes its internal clock with the PC time every time a new measurement
is prepared.
A measurement can be stopped in two different ways:
- By keystroke:
The measurement is stopped when the Start or Stop key of the data logger is pressed.
- By time:
You can set a date and time or a duration for starting a measurement.
Note:
By clicking on the „By time“ button, you can take over the current time of your PC as the time
shown in that window.
Of course, an ongoing measurement can always be terminated manually via the software, by
clicking on the icon in the group “Data Logger”.
Selecting the duration of a measurement
If "By time" is selected for both start and stop, either a start and stop time or a start time and
duration can be specified.
The stop time is changed automatically as soon as either the start time or the duration is changed.
The resulting stop time is always calculated from the start time plus the duration.