Manual

© PCE Instruments
27
English
5.2 Configuration of parameters
Menu
Function
M00
View three totalisers (positive, negative, net), signal strength, signal quality
and operating status
M01
Indication as in M91, volume flow, velocity, signal strength, signal quality and
operating status
M02
View negative totaliser, volume flow, velocity, signal strength, signal quality
and operating status
M03
View net totaliser, volume flow, velocity, signal strength, signal quality and
operating status
M04
Indication of battery voltage and remaining battery life
M10
Enter outer perimeter of pipe
M11
Enter outer diameter of pipe, value between 0 and 6,000 mm can be selected
M12
Enter wall thickness of pipe
M13
Enter inner diameter of pipe
M14
Select standard pipe material (if pipe material is included here, no pipe sound
velocity is needed):
0. Carbon Steel, 1. Stainless Steel, 2. Cast Iron, 3. Ductile Iron, 4. Copper,
5. PVC, 6. Aluminium, 7. Asbestos, 8. Fiber Glass 9. Other
M15
Enter pipe sound velocity; only necessary if material does not belong to
standard materials
M16
Select liner material; if the pipe used does not have a liner, select „0. No Liner“
1. Tar Epoxy, 2. Rubber, 3. Mortar, 4. Polypropylen, 5. Polystyrol,
6. Polystyrene, 7. Polyester, 8. Polyethylene, 9. Ebonite, A. Teflon, B. Other
M17
Enter liner sound velocity; only necessary if “B. Other” has been selected
under M16
M18
Enter material thickness of liner; only necessary if “B. Other” has been
selected under M16
M19
Enter absolute thickness of inner wall
M20
Select standard liquid:
0. Water, 1. Sea Water, 2. Kerosene, 3. Gasoline, 4. Fuel Oil, 5.Crude Oil,
6. Propane, 7. Butane, 8. Other, 9. Diesel Oil, 10. Castor Oil,
11. Peanut Oil, 12. Gasoline ROZ 90, 13. Gasoline ROZ 93, 14. Alcohol, 15.
Water (125 °C)
M21
Enter fluid sound velocity; only necessary if liquid does not belong to standard
liquids
M22
Enter viscosity of liquid (only necessary if liquid does not belong to standard
liquids)
M23
Select sensors out of 16 types:
1. User Insert
2. Insert C11_45
3. Insert C11_60
4. Clamp-On M2 (TDS-M1)
5. Clamp-On S1
6. Clamp-On S2 (TDS-S1)
7. Clamp-On L2 (TDS-L1)
8. Clamp-On TS-2
9. Standard-HS (TDS-HS)
10. Standard-HM (TDS-HM)
11. Clamp-On TL-1
12. Clamp TM-1
13. Clamp-FS410
14. Insert C15_45
15. Insert C15_51