Manual

English

6.4 Menu overview

1. Measure Config

2. Gauge Config

3. Data

1.1 Memory Location

2.1 Buzzer

3.1 USB

1.2 Strike Direction

2.2 Backlight

3.2 File No.

1.3 Threshold Values

2.3 Language Set

3.3 File List

1.4 Average Time

2.4 Software Ver

3.4 Delete Data

1.5 Material Type

1.6 Hardness Scale

1.7 Probe Option

6.5 Settings

Switch on the device by pressing the On/Off key . You are now in measurement mode.

In order to enter the menu, press the Menu key . In the menu, you will see the icons of the

three menu items.

You can select one of the three menu items by using the arrow keys and .

Confirm your selection by pressing the Menu key again.

In order to return to measurement mode, press the Back key . This key is also used to and

confirm any changes made.

1. Measuring configuration

1.1 Memory Location

Here you can determine what file no. the measured values will be saved under. 5 memory

locations are available.

Use the arrow keys and to select a number between 0 and 5.

To return, press the Back key . This key is also used to and confirm any changes made.

1.2 Strike Direction

The arrows in the display show the impact

direction of the impact body. (DIR)

Possible measuring directions:

down (– 90°)

down left or down right (– 45°)

left or right (0°)

up left or up right (45°)

up (90°)

automatic (Indication: DIRC auto)

Note: You can also select the measuring direction directly via the Direction key when

switching on the device.