Edition EN03

Manual PCD2.W525&PCD3.W525│Document 26/853; Edition EN03│2013-09-18
Saia-Burgess Controls AG
Conguration
Hardware
1-2
1
1.2 Conguration
1.2.1 Module connections/LED
Theconnectionsofthemoduleterminalarethefollowing:
DescriptionoftheLED:
● Off:  Moduleisnotpowered.U
ext
(24V)ismissing.
● On:  Moduleisrunningwithouterrors
● Blinkingslow: Channelerror(Overrange/underrange/shortcircuit/openload)
● Blinkingfast: U
ext
islowerthanspecified(<19V)
1.2.2 Howtoconguretheinputs
EachinputchannelisconguredbyaDIP-Switchwithfourswitches.Thefunctionof
eachswitchisthefollowing:
Switch nr. Off On
1
2
3
4
Differential Mode
Gain=1
SingleEndedMode
CurrentShuntOn
SupplyforexternalResistorsOn
Gain=0.25
Accordingtothistable,thecongurationforthedifferentmodesofoperationisas
follows:
Voltage mode
0...10 V
Current mode
0...20 mA
4...20 mA
Temperature mode
Pt1000 (-50...400 ˚C)
Pt500 (-50...400 ˚C)
Ni1000 (-60...200 ˚C)
Resistor mode
0...2500 Ω
1.2.3 Howtoconguretheoutputs
Sincetheoutputsareconguredbysoftware(withthecorrespondingFBoxorFB),
thereisnoneedtocongurethemodeofoperationoftheoutputswithanykindof
jumpersorDIP-Switches.