User's Manual

Purple
Solid: Regiester to2G(not connect)
Blink: Connected to2G network
Red
Blink:No Service/Device Error
WiFi LED
Blue
Solid:No Client
Slow Blink: Client is actived
Fast Blink: WPS is actived
Blink:
Turn on-0.2s
Turn off-0.1s
Installation
Follow the diagram to install the SIM card and SD card
Tips: Always switch the device off and disconnect the charger before removing the battery.
1. Remove the back cover and battery;
2. Insert the SIM card and SD card. Ensure that the contact area on the card is facing down and that the beveled
corner on the card is facing the beveled corner on the holder.
3. Align the battery contacts with the battery compartment connectors, and insert the battery. Replace the back
cover lastly.
Charge
Your battery has been partially charged at the factory. If the device indicates a low charge, do the following:
1. Connect the charger to an outlet.
2. Connect the USB charger plug to your device’s USB port.
3. When the device indicates a full charge, disconnect the charger from the device, then from the outlet.
One：Using charge adapter