User Guide

4B. WAN Settings 25
WAN Settings
3. Select Enabled from GPS Enable option button to
enable the GPS feature. The
GPS EULA alert opens
if you haven't accepted the GPS EULA (End User
License Agreement). You cannot use GPS until you
accept the GPS EULA.
4. Select the mapping service (Yahoo, Google,
Microsoft, etc.) to search and display the GPS
results.
5. Select enable or disable the GPS privacy mode.
6. Select Imperial or Metric in the Measurement
Standard drop-down list box.
7. Select to display or hide the GPS LBS (Location
Based Services) information including
Status,
Latitude, Longitude, Altitude, Speed, Heading,
Satellites, HEPE and Last Fix. GPS LBS information
is used to provide enhanced local search features
via Internet mapping services.
8. Click Apply to save and validate the configuration,
click
Cancel to cancel the configuration, or click
Reset to restore to the default GPS settings.
Data Link Settings
To configure the data link settings:
1. From the Web management page, click the
Settings tab.
2. Select WAN > Data Link.
3. Select Change Profile to set the active profile if
applicable.
4. Select use cases in the Prompt Type drop-down
combo box. Three use cases are supported:
䡲 DataLink Scenario A: In this scenario, the user is
always prompted for their Data Link username
and password each time they connect.
䡲 DataLink Scenario B: In this scenario, the user is
prompted for their username once initially and
then prompted again to enter their password
each time they connect.
䡲 DataLink Scenario C: In this scenario, the user is
prompted for the username and password for the
first time. The credentials are then written to the
device.
Note: If you want to disable the GPS feature, select Disabled
from the
GPS Enable option button. By default, Sprint
Location Service is disabled.