User Guide

2B. Installation and Startup 11
Installation and Startup
storage. When connected to a computer through the
USB cable, the microSD card is recognized as a
removable storage device.
To install a microSD card:
1. Power off the device and remove the back cover
and battery. See “Installing or Removing the
Battery” on page 10.
2. Insert the microSD card into the microSD card slot.
Push it in until it clicks into place.
3. Replace the battery and the back cover, and the
power the device back on.
To remove a microSD card:
1. Power off the device and remove the back cover
and battery. See “Installing or Removing the
Battery” on page 10.
2. Push in on the microSD card to release it from the
slot, and then carefully remove it from the device.
3. Replace the battery and the back cover, and the
power the device back on.
Charging the Battery
Sprint-approved or manufacturer-approved batteries
and accessories can be found at Sprint Stores, or call
1-866-866-7509 to order. They’re also available at
www.sprint.com.
Battery Capacity
Your device is equipped with a Lithium Ion (Li-Ion)
battery. It allows you to recharge your battery before it is
fully drained.
WARNING: Before installing or removing a microSD card,
power off the device to protect the device and the
SD card from being damaged.
WARNING: Using microSD cards larger than 32 GB may
cause data loss and damage your device.
WARNING: Use only Sprint-approved or manufacturer-
approved batteries and chargers for your device.
The failure to use a Sprint-approved or
manufacturer-approved battery and charger may
increase the risk that your device will overheat,
catch fire, or explode, resulting in serious bodily
injury or property damage.