User Guide

10 2B. Installation and Startup
⽧ Installing or Removing the Battery (page 10)
⽧ Installing or Removing a Card (page 10)
⽧ Charging the Battery (page 11)
⽧ Turning Your Device On or Off (page 12)
⽧ Checking the Device Status (page 14)
Installing or Removing the Battery
To install the battery:
1. Remove the back cover. Slide the back cover
down in the direction of the triangle to remove it.
2. Insert the battery into the battery slot, making sure
the connectors align (see Diagram A). Gently press
down to secure the battery.
3. Replace the back cover. Place it over the back of
the device and slide up until it pops into place.
To remove the battery:
1. Turn the device off to avoid any data loss. Press
and hold the Power button for about 3 seconds.
2. Remove the back cover. Slide the back cover
down in the direction of the triangle to remove it.
3. Lift the battery out from the bottom (see Diagram
B).
Installing or Removing a Card
Your device supports up to a 32 GB microSD card
(sold separately) for file sharing and transferring or
2B. Installation and Startup
WARNING: Do not handle a damaged or leaking Li-Ion
battery as you may be burned.
Diagram A Diagram B