User manual
INSTALL BATTERY
1. Remove the battery cover from the unit.
2. Slide the battery into the slot by aligning the contacts located at the
bottom of the unit and press down until you hear the “click”.
3. Align the cover tabs with the slots at the top of the device and slide
the battery cover back onto the unit.
REMOVE BATTERY
1. To remove the battery, push down on the top of the battery while
inserting your finger into the slot (1) and pulling up from the back of
the battery and slide it out (2).
2. Align the cover tabs with the slots at the top of the device and slide
the battery cover back onto the unit.
If the battery is not correctly placed in the compartment, the handset will not turn on
and/or the battery may detach during use.
12
Chapter 1 − Before Using CDM8950
Before UsingBefore Using
CHARGING YOUR BATTERY
1. To charge the phone, open the Charging/Data Jack cover on the
bottom of the phone and connect the charger adapter. Plug the other
end into a standard outlet.
2. To remove the adapter connection, squeeze the adapter’s side
buttons (1) and pull (2).
•
When you charge the battery with the phone power off, you will see a charging status
screen. You cannot operate the phone until it is powered on.
•
The battery is not fully charged at the time of purchase. Fully charge the battery
before use.
•
It is more efficient to charge the battery with the handset powered off.
•
Battery operating time gradually decreases over time.
•
If the battery fails to perform normally, you may need to replace the battery.
BATTERY HANDLING INFORMATION
DO’S
•
Only use the battery and charger approved for use with the CDM8950.
•
Only use the battery for its original purpose.
•
Try to keep batteries in a temperature between 41 °F (5 °C) and 95 °F (35 °C). If
the battery is stored in temperatures above or below the recommended range,
give it time to warm up or cool down before using.
•
Completely drain the battery before recharging.
•
Store the discharged battery in a cool, dark and dry place.
•
Purchase a new battery when the battery’s operating time gradually decreases
after fully charging.
•
Properly dispose of the battery according to local laws.
DON’TS
•
Don’t attempt to disassemble the battery – it is a sealed unit with no service-
able parts.
•
Don’t accidentally short circuit the battery by carrying it in your pocket or purse
with other metallic objects such as coins, clips and pens. This may critically
damage the battery.
•
Don’t leave the battery in extremely hot or cold temperatures. Otherwise, it could
significantly reduce the capacity and lifetime of the battery.
•
Don’t dispose of the battery by placing into a fire.
Before Using CDM8950 − Chapter 1
13
Before UsingBefore Using
081002_CDM8950_ECHO_EN_REV00.indd 12-13081002_CDM8950_ECHO_EN_REV00.indd 12-13 2008.10.6 6:17:40 PM2008.10.6 6:17:40 PM