User's Manual

Carfi S100 User Manual



FCC Statement

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may

cause undesired operation.

2. Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

SAR Information Statement

The device is a radio transmitter and receiver. It is designed and manufactured not to

exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal

Communications Commission of the U.S. Government. The exposure standard employs a

unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by

the FCC is 1.6 W/kg. In general, the tests are performed in positions and locations (e.g., at

the ear and worn on the body) as required by the FCC for each model. The highest SAR

value for this device when worn on the body is 1.073W/Kg.

SAR information on this device is on file with the FCC and can be found under the

Display Grant section of http://www.fcc.gov/ oet/fccid after searching on

FCC ID: 2ALJJCARFI, Additional information on Specific Absorption Rates (SAR) can

be found on the Cellular Telecommunications Industry Asso-ciation (CTIA) web-site at

http://www.wow-com.com.

Body-worn Operation

This device was tested for typical body-worn operations. To comply with RF exposure

requirements, a minimum separation distance of 0mm must be maintained between the user’s

body and the handset, including the antenna. Third-party belt-clips, holsters, and similar

accessories used by this device should not contain any metallic components. Body-worn

accessories that do not meet these requirements may not comply with RF exposure

requirements and should be avoided. Use only the supplied or an approved antenna.