User's Manual

Page 6 of 14
Programming the Echo
®
Wireless Sensor
The Echo
®
Wireless Vibration Sensor can be programmed with a computer running the
Echo
®
Data Server software through a serial port.
If your computer is not equipped with a serial port, a USB to RS232
adaptor can be used. These are readily available from computer
electronics vendors.
Attaching the Programming Cable
To begin programming the Echo
®
Wireless Vibration Sensor, unscrew the cap carefully
to expose the USB port inside the sensor. Carefully attach the programming cable to the
sensor and your computer’s serial port (use the USB to RS232 adaptor if necessary).
Connecting to the Sensor with the Echo
®
Data Server Software
Launch the PCB Echo
®
Data Server and click Echo
®
EchoPlus
®
Sensors under the
Configuration drop down menu in the upper left hand corner of the screen.
Tip