User`s guide

27
Chapter 3: BIOS Setup Utility
Features Setup Page
This page sets up some parameters for peripheral devices
connected to the system.
OnBoard Floppy Controller
Use this item to enable or disable the onboard floppy disk drive
interface.
Serial Port1 Address
Use this item to enable or disable the onboard COM1/2 serial
port, and to assign a port address.
OnBoard IR Port
Use this item to enable or disable the onboard infrared port, and
to assign a port address.
Parallel Port Address
Use this item to enable or disable the onboard Parallel port, and
to assign a port address.
CMOS SETUP UTILITY – Copyright (C) 1985-2003, American Megatrends, Inc.
Features Setup
OnBoard Floppy Controller Enabled
Serial Port1 Address 3F8/IRQ4
OnBoard IR Port Disabled
Parallel Port Address 378
Parallel Port Mode ECP
ECP Mode DMA Channel DMA3
Parallel Port IRQ IRQ7
OnBoard PCI IDE Controller Both
Audio Device Enabled
Ethernet Device Enabled
Modem Device Auto
OnBoard USB Function Enabled
USB Function for DOS Disabled
USB 2.0 Controller Enabled
*****On-Chip Serial ATA Setting*****
On-Chip Serial ATA Enhanced Mode
Serial ATA Port0/1 Mode P0-3rd/P1-4th
Help Item
Allows BIOS to
Enable or Disable
Floppy Controller.
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
F1: General Help F9: Optimized Defaults