User`s guide

Motherboard User’s Guide

Power Management Setup Page

This page sets some parameters for system power management operation.

ACPI Suspend Type

Use this item to define how your system suspends. In the default, S3 (STR), the

suspend mode is a suspend to RAM, i.e., the system shuts down with the

exception of a refresh current to the system memory.

Power Management Setup

Help Item

Select the ACPI

state used for

System Suspend.

Press <Esc> to return to the main menu setting page.

: Move Enter: Select +/-/: Value F10: Save Esc: Exit

F1: General Help F9: Optimized Defaults

ACPI Suspend Type S3 (STR)

Soft-off by PWR-BTTN Instant Off

PWRON After PWR-Fail Power Off

Resume By PCI/PCI-E/Lan PME Disabled

Resume By USB(S3) Disabled

Resume By PS2 KB(S3) Disabled

Resume By PS2 MS(S3) Disabled

Resume By Ring Disabled

Resume on RTC Alarm Disabled

Parallel Port Mode

ECP Mode DMA Channel

Use this item to assign the DMA Channel under ECP Mode function.

Parallel Port IRQ

Use this item to assign IRQ to the parallel port.

Use this item to select the parallel port mode. You can select Normal (Standard

Parallel Port), ECP (Extended Capabilities Port), EPP (Enhanced Parallel Port), or

BPP (Bi-Directional Parallel Port).

Parallel Port Address

Use this item to enable or disable the onboard Parallel port, and to assign a port

address.

Soft-Off By PWR-BTTN

Under ACPI (Advanced Configuration and Power management Interface) you can

create a software power down. In a software power down, the system can be

resumed by Wake Up Alarms. This item lets you install a software power down

that is controlled by the power button on your system. If the item is set to Instant-

Off, then the power button causes a software power down. If the item is set to

Delay 4 Sec, then you have to hold the power button down for four seconds to

cause a software power down.