User`s guide

27
Chapter 3: BIOS Setup Utility
This page sets up some parameters for peripheral devices connected to the
system.
CMOS Setup Utility – Copyright (C) 1985-2007, American Megatrends, Inc.
Integrated Peripherals
Help Item
Integrated Peripherals Page
Onboard IDE Controller Enabled
OnChip S-ATA Controller Enabled
SATA Mode select SATA Mode
Onboard Audio Function Enabled
Onboard LAN Function Enabled
Onboard LAN Boot ROM Disabled
USB Controller Enabled
Legacy USB Support Enabled
Parallel Port Address 378
Parallel Port Mode ECP
ECP Mode DMA Channel DMA3
Parallel Port IRQ IRQ7
OnBoard IDE Controller
Onboard S-ATA Controller
OnBoard LAN Function
Use this item to enable or disable the onboard LAN function.
OnBoard LAN Boot ROM
Use this item to enable or disable the booting from the onboard LAN or a network
add-in card with a remote boot ROM installed.
Onboard AUDIO Function
Use this item to enable or disable the onboard IDE interface.
This item allows you to enable or disable the onboard SATA controller.
SATA Mode select
Use this item to enable or disable the onboard audio device.
Use this item to select the mode of the Serial ATA.
Legacy USB Support
Use this item to enable or disable support for legacy USB devices. Setting to
Auto allows the system to detect the presence of USB device at startup. If
detected, the USB controller legacy mode is enabled. If no USB device is
detected, the legacy USB support is disabled.
This item enables the USB controller. Leave this at the default “Enabled” if
you want to connect USB devices to your computer.
USB Controller
DISABLED: disables the
integrated IDE
Controller.
ENABLED: enables the
integrated IDE
Controller.
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
F1: General Help F9: Optimized Defaults