User`s guide

Chapter 1: Introduction

Onboard I/O Ports

• Two PS/2 ports for mouse and keyboard

• One serial port

• One parallel port

• One VGA port

• One LAN port (optional)

• Four back-panel USB2.0 ports

• Audio jacks for microphone, line-in and line-out

Fast Ethernet LAN (optional)

• Single Chip 100Base-TX / 10Base-T Physical Layer Solution

• Dual Speed – 100/10 Mbps

• Half and Full Duplex

• MII Interface to Ethernet Controller

• MII Interface to Configuration & Status

• Auto Negotiation: 10 / 100, Full / Half Duplex

• Meet All Applicable IEEE 802.3, 10Base-T and 100Base-Tx Standards.

• On Chip Wave Shaping – No External Filters Required.

USB 2.0

• Compliant with Universal Serial Bus Specification Revision 2.0

• The independent OHCI USB 1.1 Host Controllers and OneEHCI USB

2.0 Host Controller,support up to eight ports.

• Supports wake-up from S1-S3

• Legacy Keyboard/Mouse support

BIOS Firmware

This motherboard uses AMI BIOS that enables users to configure many system

features including the following:

• Power management

• Wake-up alarms

• CPU parameters and memory timing

• CPU and memory timing

The firmware can also be used to set parameters for different processor clock

speeds.

Dimensions

• Micro ATX form factor of 244 x 210mm

Note: Hardware specifications and software items are subject to change

without notification.