User`s guide

Chapter 2: Motherboard Installation

Jumper Settings

Connecting two pins with a jumper cap is SHORT; removing a jumper cap from

these pins, OPEN.

Note: To avoid the system unstability after clearing CMOS, we recommend

users to enter the main BIOS setting page to “Load Optimal De-faults”

and then “Save Changes and Exit”.

CLR_COMS1: Clear CMOS Jumper

Use this jumper to clear the contents of the CMOS memory. You may need to

clear the CMOS memory if the settings in the Setup Utility are incorrect and

prevent your motherboard from operating. To clear the CMOS memory,

disconnect all the power cables from the motherboard and then move the jumper

cap into the CLEAR setting for a few seconds.

Function Jumper Setting

Normal Short Pins 1-2

Clear CMOS Short Pins 2-3

Note: Make sure the power supply provides enough SB5V voltage before

selecting the SB5V function.

USB_PWR1/2: USB Power Select Jumper

Use these jumpers to select the voltage for USB port.

Function Jumper Setting

VCC5V Short Pins 1-2

SB5V Short Pins 2-3