Specifications

Install the Mainboard
Install the mainboard in a system chassis (case). The board is an
ATX size mainboard. You can install this mainboard in an ATX
case. Make sure your case has an I/O cover plate matching the
ports on this mainboard.
Install the mainboard in a case. Follow the case manufacturer’s
instructions to use the hardware and internal mounting points on
the chassis.
PJ1
1
SW1
1
SYSFAN1
1
A
TX1
Connect the power connector from the power supply to the ATX1
connector on the mainboard. PJ1 is the CPU Vcore power
connector.
Note: While you are connecting power connectors, you must first
connect the CPU Vcore power connector PJ1, and then the
ATX1 connector.
If there is a cooling fan installed in the system chassis, connect the
cable from the cooling fan to the SYSFAN1 fan power connector
on the mainboard.
Connect the case switches and indicator LEDs to the SW1
connector. Here is a list of the SW1 pin assignments.
Pin Signal Pin Signal
1 HD_LED_P 2 FP PWR/SLP
3 HD_LED_N 4 FP PWR/SLP
5 RESET_SW_N 6 POWER_SW_P
7 RESET_SW_P 8 POWER_SW_N
9 RSVD_DNU 10 KEY
11