Installation guide

ManualsBrandsPayne ManualsHeating & cooling combined unitOfficial Payne gas heating & electric cooling

INDUCED DRAFT MOTOR MOUNT

! ij

ff ROLL(JUT

VENTHOOD FLUE_ \ SWITCH

INSHIPPING COLLECTORBLOWER BURNER MOUNTING

LOCATION BOX HOUSING RACK SCREW

Fig. 31--Blower Housing and Flue Collector Box

C990)2

FRONT

ACCESS PANEL

C990g'1

Fig. 32--Unit Access Panel

L CONDENSER COIL, EVAPORATOR COIL, AND

CONDENSATE DRAIN PAN

Inspect the condenser coil, cwapomtor coil, and condensate dv,dn pan at least onec each your or more o&en if necessary,

The coils am easily elaancd when dry; therefore, inspect and cleaa the coils either bulbre or after each cooling sea_n. Remove all obsmlcfious,

including weeds and slvabs, that interfere with the airflow through the eonden_r coil.

Straighten bent fins v¢ith a fin comb, If eoate4 with diet or lint, clean the coils v¢ith a vacuum elaancr, using the soft brush attachment, Be eamftfl

not to bend the flus, If coated v¢ith oil or grease, cl¢_n the coils v¢ith a mild detorgcnt-and.-wator solution. Rinse coils with clear water, using a

garden hose. Be careful not to _lash water on motors., insulation, wiring, or air filtoffs), For best results, spray condenser coil flns from inside

to outside the trail. (_intmlts vdth _:a outer and inner eonden_r coil, be sure to elc_:a between the coils, Be sure to flush all diet and debris from

the unit b_,

Inspect the drain pan and condensate dv,dn line when inspecting the enils. Cl¢_n the drain pan and condensate dmJn by mmovlng all fbreign matter

from the pan. Flush the pan and drain tube ",,iqthclear wtuar. Do not _lash water on the insulation, motor, wiring, or _ filtoffs), If the drain tube

is restricted, elaar it W'ith a "plumbers snake" or s_ probe device, Ensure that the au.'xillary drain port above the dv,dn tube is also clear

M. CONDENSER FAN

A CAUTION: Keepthec_ndenserfanfreefr_ma___bstructi_nst_ensurepr_perc___ing_perati_n-Neverp_aceartic_es

on top of the unit. Damage to unit may result.

1. Remove 6 screws holding eondeusar grille and motor to top cover,

2. Turn motor/_'illa assembly upside dmvn on top cover to expose the fan blade,

m3.'_-