Installation guide

Table 1--Physical Data--Unit PYIP (Continued)
UNIT SIZE PYIP
NOMINAL CAPACITY (ton)
OPERATING WEIGHT (lb.)
COMPRESSORS
Quantity
REFRIGERANT (R-22)
Quantity (lb.)
REFRIGERANT METERING DEVICE
Orifice ID (in.)
CONDENSER COIL
Rows.-Fins/in.
Face Area (sq ft)
CONDENSER FAN
Nominal Cfm
Diameter (in.)
Motor Hp (Rpm)
EVAPORATOR COIL
Rows._Fins/in.
Face Area (sq ft)
EVAPORATOR BLOWER
Nominal Airflow (Cfm)
Size (in=)
Motor Hp (Rpm)
FURNACE SECTION*
Burner Orifice No. (Qty._Drill Size)
Natural Gas
Burner Orifice No. (Qty._Drill Size)
Propane Gas
RETURN-AIR FILTERS (in.)1"
Throwaway
048090 048115 060115 060139
4 4 5 5
415 415 450 450
Scroll Reciprocating
1 1
6.0 6.0 8.0 8.0
.032
1._17
12.3
3600
22
V, (1100)
3._15
4.7
1600
11 X 10
3/4 (1075)
3...38
3._46
24 X 30
.032
1...17
12.3
3600
22
¼ (1100)
3._15
4.7
1600
11X 10
3/4 (1075)
3...33
3-.42
24 X 30
048130 060090
4 5
415 450
6.0 8.0
Acut rol Device
.032 .030
1...17 2._17
12.3 12.3
3600 3606
22 22
I/, (1100) ¼ (1100)
3.-15 4-.15
4.7 4.7
1600 2000
11X10 11X10
3/4 (1075) 1.0 (1075)
3...31 3.-38
3.-41 3-.46
24 X 30 24 X 30
.030
2...17
12.3
3600
22
¼ (1100)
4_,15
4.7
2000
11 X 10
1.0 (1075)
3_.33
3...42
24X30
.030
2...17
12.3
3600
22
V, (1100)
4...15
4.7
2000
11 X 10
1.0 (1075)
3...31
3...41
24 X 30
* Based on altitude of 0 to 2000 ft.
Required filter sizes shown are based on the larger of the ARI (Air Conditioning and Refrigeration Instffute) rated cooling airflow or the heating airflow velocity of 300
ft/minute for throwaway type or 450 ftlminute for high-capacity type. Air filter pressure drop for non-standard filters must not exceed 0.08 in. wg.
Table 2iphysical DataiUnit PY2P
UNIT SIZE PY2P
NOMINAL CAPACITY (ton)
OPERATING WEIGHT (lb.)
COMPRESSORS
Quantity
REFRIGERANT (R-221
Quantity (lb.)
REFRIGERANT METERING DEVICE
Orifice ID fin.)
CONDENSER COIL
Rows...Fins/in.
Face Area (sq ft)
CONDENSER FAN
Nominal Cfm
Diameter (in.)
Motor Hp {Rpm)
EVAPORATOR COIL
Rows...Fins/in.
Face Area (sq ft)
EVAPORATOR BLOWER
Nominal Airflow (Cfm)
Size (in.)
Motor Hp {Rpm)
FURNACE SECTION*
Burner Orifice NO. (Qty...Drgl Size)
Natural Gas
Burner Orifice NO. (Qty...Drgl Size)
Propane Gas
RETURN*AIR FILTERS (in.)_
Throwaway
* Based on altitude of 0 1o 2000 ft.
624040 024060 630046 030060 036060 636096 042060 042090
2 2 2½ 2½ 3 3 3½ 3½
290 290 313 313 321 321 382 382
Scroll
1
3.7 3.7 4.4 4.4 5.2 5.2 6.4 6.4
.034 .034 .030 .030 .032 .032 .034 .034
1...17 1...17 1...17 1...17 2._17 2...17 2...17 2...17
10.8 10.8 12.7 12.7 g.f 9.1 12.3 12.3
2350 2350 2350 2350 2350 2350 3300 3300
22 22 22 22 22 22 22 22
1/8 (825) i/8 (825) 1/8 (825) 118 (825) 1_ (825) 1/8 (825) im (825) 1/8 (825)
3...15 3...15 3...15 3...15 3...15 3...15 3...15 3...15
3.1 3.1 3.1 3.1 3.7 3.7 4.7 4.7
800 800 1000 1000 1200 1200 1400 1400
10X10 10X10 10Xf0 i0X10 11X10 11X10 11X10 11Xf0
iN (1075) 1/4(1075) 114 (1075) 1_ (1075) 1/2(1075) i/2 (1075) 3/4 (1075) 314 (1075)
2...44 2...38 2...44 2...38 2._38 3...36 2...38 3...38
2...50 2...46 2...50 2...46 2...46 3...46 2...46 3...46
20X20 20X20 20X20 20X20 20X24 20X24 24X30 24X30
Required filter sizes shown are based on the larger of the ARI (Air Conditioning and Refrigeration institute) rated cooling airflow or the heating airflow velocity of 300
ft/minute for high-capacity type. Air filter pressure drop for non-standard filters must not exceed 0.08 in. wg.
NOTE: Pressure test the gas supply system after the gas supply piping is connected to the gas valve. The supply piping must be disconnected
from the gas valve during the testing of the piping systems when test pressure is in excess of 0,5 psig. Pressure test the gas supply piping system
at pressures equal to or less than 0.5 psig. The unit heating section must be isolated from the gas piping system by closing the external main manual
shutoff valve and slightly opening the ground-joint union.
.... I0 ....