Installation guide

BDHTACTDR24VACCOM
O
OFF:NO 24VAC
ON:OK
FLASH:PHASE PROBLEM
@
L3 L1
0
Fig. 4i3 Phase Monitor Control
Table 2--Phase Monitor LED Indicators
LED STATUS
OFF No call for compressor operation
FLASHING Reversed phase
ON Normal
A00010
PROCEDURE II--CHECK CHARGE
A. Unit Charge
Factory charge is shown on unit rating plate. (See Fig. l.)Charge procedure is shown on wiring/charging label located on unit.
CAUTION: Compressor damage may occur if system is overcharged.
CAUTION: Do not vent refrigerant to atmosphere. Recover during system repair or final unit disposal.
CARE AND MAINTENANCE
For continuing high performance, and to minimize possible equipment failure, it is essential that periodic maintenance be performed on this
equipment. Consult your servicing contractor or User's Manual for proper frequency of maintenance. Frequency of maintenance may vary
depending upon geographic areas, such as costal applications.
Leave User's Manual with homeowner. Explain system operation and maintenance procedures outlined in manual.
..... 5 ....