User’s Manual PT‐80
Version 1.0 01/2019 All rights reserved. Copyright © 2019 No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form, by any means (electronic, photocopying, recording, or otherwise) without the prior written permission of the publisher.
Table of Contents Contents Table of Contents .............................................................................................................................................................. 3 1. Introduction ......................................................................................................................................................... 4 Explanation of Advisements ..........................................................................................................
1. Introduction Welcome to your PT‐80 Tablet PC. To ensure the optimal performance of this product, please take the time to read this manual carefully. The PT‐80 is a rugged tablet designed for use in correctional facilities. Explanation of Advisements In this manual we use three (3) levels of Advisements as follows: The Note symbol is used for notifying the user of something important or of something that needs special attention.
2. Device Layout Front and side views Component MIC Front Camera Charge LED Indicator MIC Speaker Lock Docking Connector Headset Telephone Receiver Volume + Button Volume ‐ Button Power Button Description Audio Recording Device Record Still and Video Images White Blinking Light – Battery Charging Solid Green – Charge Complete Red Blinking Light – Low Battery (Battery Below 10%) Audio Recording Device Sends Out Audio For locking tablet in associated wall charger.
Rear View Component SN Label Rear Camera Description Position to place SN Label Record Still and Video Images 3. Managing Device Power Docking station You can charge the PT‐80 tablet using a Docking station. The docking station has a DC input and a USB Port, the docking connecter is shown in the layout Front view in chapter 2.
Use only the docking station included with your Tablet PC. Using other docking stations may damage the device. Power Supply and Batteries The PT‐80 device has one rechargeable battery. Android OS will give battery warnings at certain battery levels. If the PT‐80 device is not charged or powered by the power supply, the PT‐80 device will shut down automatically. For more information, more details about the specification, please see Appendix A‐ Technical Specifications To charge the Battery Pack: 1. 2. 3.
Checking the charging Level To check the battery charge level of the PT‐80, the battery monitor is shown on the Android Top navigation bar. Power LED Behavior on the Docking station The Power LED will only shine when the Power adapter is plugged in. Green — Fully charged Blue — Charging 4. Using the PT-80 No special skills are required to setup the PT‐80 device. Follow this User’s Manual and the Quick Start Manual.
Adjusting the Volume To adjust the volume, use the Volume Up and Down buttons on the upper side of the PT‐80 device. For position references, see the layout in Chapter two. Volume adjustments can also be adjusted in AndroidOS. 5. Product Care Temperature & Humidity General Use - Operating temperature The PT‐80 is best kept in dry conditions at room temperature.
any power source. Then contact your supplier’s technical support office for repair. Do not service or perform maintenance on the device while the device is in use. Make sure to shut the device down and unplug all cables before starting and service or maintenance work on the device. 2.1 Power Supply and Batteries The PT‐80 device contains one rechargeable battery. All rechargeable batteries degrade over time.
Use in direct sunlight or in any other hot environment may cause the PT‐80 device to develop hot surfaces. There is a built‐in temperature sensor that monitors the device temperature. If the sensor detects high internal temperature, the device will automatically trigger a Shut Down. It may take a while before PT‐80 device can be restarted as the unit may first need time to cool down. 2.3 Electricity The device contains no user serviceable parts. Do not open the case of the PT‐80 Tablet Device.
Appendix A Technical Specifications Processor OS System Memory: Storage: LCD: Touch Screen: Top Glass: Audio jack: Imaging/input Wireless Sensors Battery Dock LED Chassis Durability Regulatory Cert RK3368 Octa‐core Cortex‐A53 G6110 GPU Android 7.1.2 2GB DDR 16G Flash 8” LCD 800 x 1280 resolution, 300nits Multi‐touch capacitive PMMA+PC Headphone and Microphone 3.5 mm 1xSpeaker, 1xHeadset Front camera: 2M Rear camera: 2M Wi‐Fi 802.11 a/b/g/n/ac 3‐axis accelerometer. Light sensor 3200mA 7.4V battery, 23.
Modifications not expressly approved by Device Manufacturer could void the user’s authority to operate the equipment under FCC rules. Part 15B Equipment This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
