Compact Keypad Grey Black Exit button (push to make) 12-15V DC White (fuse rating 1A) - +12V DC + * 0V 12V DC release current rating must be less than 1A. * The diode current rating must be equal to or greater than the current required to drive the release.
Please read the following notes before installing Electrical shock from voltages used in this system can cause injury or death. Prior to making any electrical connections, or performing maintenance and repair, ensure power is removed. Mains electrical connections should be made only by qualified personel in accordance with local regulation. 1. Safety goggles should be worn while using power tools. 2. Before drilling the mounting holes, check the area for concealed wires and pipes. 3.
Setting The Master Code The first time the keypad is turned on the RED and GREEN LEDs flash alternately. This indicates a 6 digit Master Code must now be entered. »The Master Code allows access to the Programming Menu.
Changing the keypad backlight Enter 6 digit Master Code The RED and GREEN LEDs flash simultaneously indicating reader is in Programming Mode Press and hold for 3 seconds 0 { *# } = On press = Off Setting multiple entry codes (maximum = 120) Press # = default to exit programming mode Enter 6 digit Master Code The RED and GREEN LEDs flash simultaneously indicating reader is in Programming Mode Press and hold for 3 seconds 2 { *# } = On press = Off Press # to exit programming mode When in Mu
Setting the keypad for additional security Enter 6 digit Master Code The RED and GREEN LEDs flash simultaneously indicating reader is in Programming Mode Press and hold for 3 seconds 4 { *# } = On # press = Off When enabled, the keypad will deactivate for 60 seconds if there are 20 consecutive incorrect numbers entered Press to exit programming mode = default Changing the Master code Enter 6 digit Master Code The RED and GREEN LEDs flash simultaneously indicating reader is in Programming Mode Pr
Applications - Using an exit button. This is used to exit through the door. A standard ‘bell push’ button, fitted on the safe side of the door can be used to operate the electric release. + - 12-15V d.c. (Fuse rating 1A) Push to make door release 1 2 3 4 5 6 7 8 9 * 0 # Schematic shows a 12V d.c. release. The current rating must be less than 1A +12Vd.c. The diode current rating must be equal to or greater than the current in the release. 0V - Providing timed access.
Technical Help Here is the list of topics about this product that receive the most technical support enquiries. We list them here to help you speed up the installation and trouble shooting process. 1. I have connected the keypad correctly. Why doesn’t it open when I enter my code? QQ QQ QQ- Check that there is power to the keypad by setting the keypad backlight to ON, and listening for keypad beeps. If not, check the power supply. Check that the green light flashes when the correct code is entered.
