Instruction Manual

e l b a e g r a h c e R d e l a e S

B a tte r y

h A 7 V 2 1

V 2 1

V 0

V 2 1

V 0

V 2 1

V 0

U S P

V 0

INPUT A C 100-240V

50 / 60 Hz

1.2A

OUTPUT DC 13.8V 2A

Ins-30039 2A/12V DC boxed power supply with Net2 ACU

16/04/2013

Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT)

Saturday from 09:00 - 13:00 (GMT)

01273 811011 support@paxton.co.uk

Technical Support

Paxton Net2

control unit

Back-up battery

MAINS POWER

Tamper Switch

Layout

12V DC Outputs

Ratings Label

Mains Failure Monitoring

The Tamper switch type and position will vary due to the different case styles.

Documentation on all Paxton products can be found on our website - http://www.paxton.co.uk/

Paxton

IMPORTANT: The equipment connected to this power supply

must not exceed its 2A rating.

PAGE 1
6/04/2013 Paxton Ins-30039 2A/12V DC boxed power supply with Net2 ACU Technical Support 01273 811011 support@paxton.co.uk Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT) Saturday from 09:00 - 13:00 (GMT) Documentation on all Paxton products can be found on our website - http://www.paxton.co.uk/ Layout 0V 0V PSU 0V 12V 0V 12V 12V 12V DC Outputs Mains Failure Monitoring Paxton Net2 control unit INPUT OUTPUT AC 100-240V 50 / 60 Hz 1.2A DC 13.
PAGE 2
5 mm 116 mm Fitting 1. Screws and wall plugs are provided in a fitting kit. With reference to the diagrams, determine where the top, central mounting position is required and drill a hole suitable for a No 8 wall plug. 2. Tap in one of the wall plugs. 3. Put in one of the long screws, leaving a suitable gap to the wall surface and slide the cabinet over it. 320 mm 4. Mark the hole positions for the lower 2 screws. 5. Remove the cabinet and drill the additional holes. Metal Cabinet 268 mm 6.
PAGE 3
Status Lights Green This LED is on when the input supply is healthy. Red This LED is on when the input supply has failed - Power is being supplied by the battery. Features Battery backup The cabinet can accommodate a 12V / 7Ah battery. Fast/Trickle charge The battery is continuously charged to keep it at maximum capacity. Deep discharge protection If battery voltage falls below 9.5V, it will automatically disconnect - Red LED goes out.